ICY-30 Insert cable & Connectors

INSERT CABLE FOR BILLY SHEEHAN PEDALS (ICY-30)    Examples

INSERT CABLE FOR BILLY SHEEHAN PEDALS (ICY-30)   

ICY-30

The EBS ICY-30 Insert Cable for use with the Billy Sheehan Signature Drives


Connect the 1/4" Stereo Contact of the ICY-30 to one of the Loops (Clean or Drive) on the Billy Sheehan pedals to add external effects, equalizers or on/off switches to either the Clean or the Drive channel of the Billy Sheehan pedal. The cable works for any other item that make use of a y-type insert cable too, of course. Available models: ICY-30, 30 cm  

Examples

Example 1: An OctaBass is connected to the Clean Loop using an ICY-30 cable feeds the OctaBass with a clean note to track, and sending back the sub octave to the clean channel of the Billy Sheehan Drive Deluxe. That way, you can use the Drive effect on top but preserve a clean sub octave sound in the bottom.  An UniChorus is connected to the Drive Loop and will only affect the distortion, and leave the clean sound unaffected.

bsd_5

 

Example 2: If you have a pedal with True Bypass laying around at no use, you can use it as an on-off switch for the Drive on the Billy Sheehan pedal by putting it backwards in the Drive loop. Benefit? Well, you would be able to use the Billy pedal as a compressor only, until you kick in the drive again.

 

hack

 

 FEATURES

 

1/4" Stereo contact at one end, split into two mono contacts representing TIP and RING of the stereo contact.

Super Compact Angled Contacts

Extremely Well Shielded

Low Resistance

INTERCONNECTION PLUGS (PL-10 & PL-20)    Example

INTERCONNECTION PLUGS (PL-10 & PL-20)   

 

PL10PL20

Interconnection Plugs (PL-10, PL-20)


Specially designed interconnection 1/4"-plugs allow you to tighten up your pedal board.   Use the PL-10 if the input/output jacks on the pedals you plan to connect are on the same height. Use the PL-20 model if the jacks are on different height, and turn the concentric cylinder until it fits.  

Available models: PL-10 Symetric connector PL-20 Assymetric connector

Example

 

conn1

 FEATURES

 

1/4" Mono connectors for use between pedals.

PL-10 model for pedals where jacks are on the same height.

PL-20 concentric model to adjust the height when not on the same level.